This screen displays the calculated drying model settings by the DryerMaster Moisture Control Platform. (DM510) Here you can view the following:
Inlet Grain Moisture and Temperature: this is wet moisture being sensed by a DM sensor located in the wet garner of the dryer
Target Setpoint
This is the target discharge moisture set from the Run Screen. The target discharge moisture can also be changed or set in this screen by clicking on the white rectangular box to drop down a key pad for numeric entry.
Predicted Moisture
This is the discharge moisture the DM Drying calculation has predicted based on current drying model.
Outlet Grain Moisture and Temperature
This is the actual discharge moisture being sensed in the DM rotary sampler located downstream in the takeaway conveyor.
NOTE: When the Target Moisture, Predicted Moisture, and the Outlet Moisture all get within .5% of each other then the DryerMaster will show READY and is prepared to run in Automatic. The Operator will need to select DM control from the Run Screen.
Suggested Rate
This is the suggested rate that DM has calculated with the current drying data being used in the drying model.
Discharge Rate
This is the actual discharge rate that unload system is running. When running in Manual this rate is set on the Run Screen. When in Automatic this rate is set by DM.
Product Type
Here the operator selects the product being dried. By pressing this box a drop-down will appear with product selection.
System Control Mode
The Status of the DM system. Idle, Learning, Ready, or Automatic.
Discharge Control Mode
Status of Metering System. Manual or Automatic
NOTE: The arrow in the upper left will advance you to the next DM Screen